Montana Tech T1010 Varnish matt 400ml

Matte varnish, UV Protection • Item ID: L-376375

(2 Customer reviews)

95 kr

Add to cart

Available in stock

Not available

Not available. Remind when product is in stock:

Add to Wish List

Montana Tech T1010 Varnish matt 400ml is a matt clear coat with UV protection in a spray can adapted for use with Montana GOLD Spray Paints. The varnish provides a matt finish and an extra hard protective surface layer. Works on most surfaces and is especially recommended if the material will be exposed to wear and tear. For example, furniture, bicycles, etc. Always test on a similar surface first to make sure you are happy with the result. 400ml.

Note! Chrome effect paints cannot be varnished, as the shimmering chrome effect disappears under the clear coat.

View all products by Montana Cans

Highlights DIY Spraykit
DIY-essentials
50 kr
Info Buy
Flat Jet Cap Wide - 10 Pack
Special effect
35 kr
Info Buy
Flat Jet Cap Medium - 10 Pack
Special effect
35 kr
Info Buy
215

Montana GOLD 400ml
The D-I-Y choice!
from 60 kr
Info Buy
$Montana Latex Gloves Black$

Montana Latex Gloves, 10-pack
Powder-free
25 kr
Info Buy
Montana Tech T1005 Varnish Semi gloss 400ml
Semi glossy varnish, UV Protection
95 kr
Info Buy
Montana Tech T1000 Varnish gloss 400ml
Glossy varnish, UV Protection
95 kr
Info Buy
Montana Tech T2300 Universal Primer 400ml
Universal primer
95 kr
Info Buy
Mirka Sanding sponge 888004
Fine Grain
25 kr
Info Buy
Mirka Sanding sponge 888002
Fine Grain
25 kr
Info Buy
15

Montana Metallic 400ml
Metallic colors
105 kr
Info Buy

Valve System: Low-Pressure
Gloss Level: Matte 4GU
Lacquer Base: NC-Acrylic
Content: 400ml

DANGER

H222-H229 Extremely flammable aerosol. Pressurised container: May burst if heated.
H319 Causes serious eye irritation.
H336 May cause drowsiness or dizziness

Documents:
attachment

Safety Data Sheet Swedish
attachment

Safety Data Sheet English

Shake can well for 2-3 minutes upside down to take advantage of gravity.
Remove the safety ring by removing the nozzle and turning the can upside down allowing it to fall out.
Then re-apply the nozzle.
Apply varnish in several thin layers, spraying before the previous coat is fully dry but with 2 minutes between each pass.
Further coats might require a drying time of 24 hours or more depending on substrate.
For optimal lifespan, always store cans with the nozzle on.
NOT COMPATIBLE WITH SYNTHETIC BASE LACQUERS.
Always test spray on a non-visible area to check compatibility of lacquer or paint.